1-17
Catalyst 2960 Switch Getting Started Guide
OL-9368-03
Chapter 1 Getting Started Guide
Rack-Mounting
either a crossover or a straight-through cable for connections to a copper 10/100
or 10/100/1000 module port on the switch, regardless of the type of device on the
other end of the connection
Install the SFP Modules and Connect to the Ports
Follow these steps:
For a list of supported modules, see the release notes on Cisco.com. For detailed
instructions on installing, removing, and connecting to SFP modules, see the
documentation that came with the SFP module.
Caution Removing and installing an SFP module can shorten its useful life. Do not remove
and insert SFP modules more often than is absolutely necessary.
Step 1
Grasp the module on the sides, and insert it
into the switch slot until you feel the
connector snap into place.
Step 2
Insert an appropriate cable into the module
port. Insert the other cable end into the other
device.
Catalyst 2960
SERIES
1X
11X
12X
SFP module
135020
Catalyst 2960
SERIES
1X
11X
12X
SFP module port
135021
To Next Page
Loading...
