24
Cisco Catalyst 2.4 GHz and 5/6 GHz Dual-Band Polarization-Diverse Directional Patch Antenna (C-ANT9103=)
Mounting on a Wall, Ceiling or Mast with AP Mounted Directly on Antenna
You can directly mount the Cisco Catalyst series C9130AX-E access point to the back of the C-ANT9103= antenna using
the AIR-AP-BRACKET-9= bracket. See Figure 12.
Step 1 Remove the rubber feet from each of the four shoulder screws on the access point.
Step 2 Loosen and remove the four shoulder screws of the AP.
Step 3 Fix the bracket to the AP using the four shoulder screws removed in Step 2. Tighten all the screws to
18-20 in-lbs (2.03-2.26 Nm).
Step 4 Fasten the four 1
1
/
8
inch-L, 8-32 thread screws to fix the AP-bracket module to the back of the antenna.
Tighten all the screws to 18-20 in-lbs (2.03-2.26 Nm).
Step 5 Cover the four 1
1
/
8
inch-L, 8-32 thread screws using the caps.
Step 6 Fix the cable to the bracket using zip ties.
Step 7 Use the four
1
/
4
-20 thread serrated flange locknut to fix the AIR-AP-BRACKET-9= bracket to the adapter
bracket. Tighten all the screws to 39-43 in-lbs (4.41-4.86Nm).
Step 8 Connect the antenna’s octal DART plug to the access point.
To Next Page
Loading...
