Cisco Catalyst Express 500 User Manual

1-13
User Guide for the Catalyst Express 500 Switches
OL-8122-01
Chapter 1 Introduction
Supported Hardware
Simple Network Management Protocol
You can use Simple Network Management Protocol (SNMP) management
applications to manage the switch. You also can manage it from an
SNMP-compatible workstation.
Supported Hardware
The switches support the PWR675-AC-RPS RPS. (Available only on the Catalyst
Express 500-24PC model.)
The switches support these Cisco SFP modules:
• 100BASE-BX
• 100BASE-FX
• 100BASE-LX
• 1000BASE-LX
• 1000BASE-SX
When You Are Done
If you have not already installed the switch and configured its basic settings, see
Chapter 2, “Setup and Installation.”
If you already installed and configured the switch with its basic settings, see
Chapter 3, “Customization,” to learn about features that can optimize the switch
performance.

Cisco Catalyst Express 500 Specifications

General

Model	Cisco Catalyst Express 500
Category	Switch
MAC Address Table Size	8000 entries
RAM	64 MB
Flash Memory	16 MB
Authentication Method	RADIUS, TACACS+
Jumbo Frame Support	Yes
Uplink Ports	2 x combo Gigabit Ethernet
PoE Support	Yes
Management	Web-based management interface
Status Indicators	system
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Features	VLAN support, QoS
Power Supply	Internal
Operating Temperature	0 to 40 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 85% (non-condensing)