Cisco CRS

RP/0/RP0/CPU0:router(config)# policy-map policy1
RP/0/RP0/CPU0:router(config-pmap)# class class1
RP/0/RP0/CPU0:router(config-pmap-c)# set qos-group 5
RP/0/RP0/CPU0:router(config-pmap-c)# exit
RP/0/RP0/CPU0:router(config-pmap)# exit
RP/0/RP0/CPU0:router(config)# interface pos 0/7/0/0
RP/0/RP0/CPU0:router(config-if)# service-policy input policy1
Related Commands
DescriptionCommand
Defines a traffic class and the associated rules that match packets to
the class.
class-map, on page 12
Identifies specific IP differentiated services code point (DSCP) values
as match criteria for a class map.
match dscp, on page 44
Creates or modifies a policy map that can be attached to one or more
interfaces to specify a service policy.
policy-map, on page 67
Attaches a policy map to an input interface or output interface to be
used as the service policy for that interface.
service-policy (interface), on page 93
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 109
Quality of Service Commands on the Cisco IOS XR Software
set qos-group