clear qos counters interface
To clear QoS counters for a specified interface, use the clear qos counters interface command in EXEC
mode.
clear qos counters interface type interface-path-id [input| output]
Syntax Description
Interface type. For more information, use the question mark (?) online help function.
type
Either a physical interface instance or a virtual interface instance as follows:
•
Physical interface instance. Naming notation is rack/slot/module/port and a slash
between values is required as part of the notation.
◦
rack : Chassis number of the rack.
◦
slot : Physical slot number of the modular services card or line card.
◦
module : Module number. A physical layer interface module (PLIM) is always
0.
◦
port : Physical port number of the interface.
In references to a Management Ethernet interface located on a route
processor card, the physical slot number is alphanumeric (RSP0RP0 or
RP1) and the module is CPU0. Example: interface
MgmtEth0/RSP0RP1/CPU0/0.
Note
•
Virtual interface instance. Number range varies depending on interface type.
For more information about the syntax for the router, use the question mark (?) online
help function.
interface-path-id
(Optional) Clears input QoS counters that are attached to the specified interface.input
(Optional) Clears output QoS counters that are attached to the specified interface.output
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 2.0
The interface keyword was added.Release 3.9.0
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 15
Quality of Service Commands on the Cisco IOS XR Software
clear qos counters interface