Cisco CRS Command Reference Guide

show qos wred-curve
To display the QoS Weighted Random Early Detection (WRED) curve data point information, use the show
qos wred-curve command in EXEC mode.
show qos wred-curve {input| output} location node-id
Syntax Description
Attaches the specified policy map to the input interface.input
Attaches the specified policy map to the output interface.output
Displays detailed QoS WRED curve information for the designated node. The
node-id argument is entered in the rack/slot/module notation.
location node-id
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.6.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readqos
Examples
The following example shows how to display QoS WRED curve information:
RP/0/RP0/CPU0:router# show qos wred-curve input location 0/1/0
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
142 OL-23235-03
Quality of Service Commands on the Cisco IOS XR Software
show qos wred-curve

Cisco CRS Specifications

General

Operating System	Cisco IOS XR
Product Type	Core Router
Form Factor	Modular Chassis
Dimensions	Varies by chassis type
Weight	Varies by chassis type
Architecture	Distributed
Switch Fabric	Multi-stage
Interface Support	Ethernet, SONET/SDH, OTN
Interfaces/Ports	Varies by line card
Port Density	Varies by line card
Routing Protocol	BGP, IS-IS, OSPF, MPLS
Management	CLI, SNMP
Power Supply	Redundant, hot-swappable
Cooling	Redundant, Hot-swappable Fan Trays
Supported Protocols	IPv4, IPv6, MPLS
Management Interfaces	Ethernet, console
Security Features	ACLs