Cisco CRS

switch-fabric service-policy
To configure a service policy for the switch fabric, use the switch-fabric service-policy command in global
configuration mode. To remove a specified service policy from the switch fabric, use the no form of this
command.
switch-fabric service-policy policy-map-name
no switch-fabric service-policy policy-map-name
Syntax Description
Name of the predefined policy map to be used as a QoS policy. The name
can be a maximum of 40 alphanumeric characters.
policy-map-name
Command Default
No service policy is specified.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeqos
Examples
The following example configures the service policy for policy map1.
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# switch-fabric service-policy map1
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 143
Quality of Service Commands on the Cisco IOS XR Software
switch-fabric service-policy