show fmgr interface
To display ternary content addressable memory (TCAM) feature entries for QoS, use the show fmgr interface
command in EXEC mode.
show fmgr interface type interface-path-id feature {policer| qos| qos-all} {input| output} [all| dup-bank|
hw| ipv4-mpls| ipv6| l2| location node-id| sw]
Syntax Description
Interface type. For more information, use the question mark (?) online help
function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface-path-id
Displays feature specific information.feature
Displays policer entries.policer
Displays QoS entries.qos
Displays entries for both QoS and policer.qos-all
Specifies the ingress direction.input
Specifies the egress direction.output
(Optional) Displays all TCAM entries.all
(Optional) Displays entries from the duplicate bank in turbo mode.dup-bank
(Optional) Reads from the hardware.hw
(Optional) Displays ipv4-mpls entries.ipv4-mpls
(Optional) Displays ipv6 entries.ipv6
(Optional) Displays Layer 2 entries.l2
(Optional) Identifies the location of the interface whose TCAM information
you want to display. The node-id is expressed in the rack/slot/module notation.
Use the show platform command to see the location of all nodes
installed in the router.
Note
location node-id
(Optional) Reads from the software.sw
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
116 OL-23235-03
Quality of Service Commands on the Cisco IOS XR Software
show fmgr interface
To Next Page
Loading...
Need help?
General
