Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.2
The in keyword was replaced with the input keyword.
The out keyword was replaced with the output keyword.
The l2 keyword was added.
Release 3.5.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readqos
Examples
The following sample output shows how to display all ingress QoS and policer TCAM entries for a Gigabit
Ethernet interface:
RP/0/RP0/CPU0:router# show fmgr interface GigabitEthernet 0/1/5/0 feature qos-all in
QOS ENTRIES
===============================================================================
Interface = GigabitEthernet0_1_5_0 Feature = qos Direction = in
TCAM Fields:
ip/mpls bndl vlg_id cid dscp exp dc qos-id
CSRAM Fields:
prio sh_q red_ctr qos_grp dc l2_mark l3_mark l3_mark_val max_th seg_size min_th
1st_seg pol_has_hpq
===============================================================================
No QoS configured on this interface
POLICER ENTRIES
===============================================================================
Interface = GigabitEthernet0_1_5_0 Feature = policer Direction = in
TCAM Fields:
IPv4: ip/mpls vlg_id l2_cos drid ip_src l4_proto frag dscp ip_dest qos_grp dc d
st_port qos-id
MPLS: ip/mpls vlg_id l2_cos label exp qos_grp dc qos-id
CSRAM Fields:
cid token1 stats_ptr conform1 exceed1 violate1 token2 conform2 exceed2 violate2
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 117
Quality of Service Commands on the Cisco IOS XR Software
show fmgr interface
To Next Page
Loading...
Need help?
General
