show qos interface
To display QoS information for a specific interface, use the show qos interface command in the EXEC mode.
show qos interface type interface-path-id {input| output} [host-link interface-path-id| location node-id]
Syntax Description
Interface type. For more information, use the question
mark (?) online help function.
type
Either a physical interface instance or a virtual
interface instance as follows:
•
Physical interface instance. Naming notation is
rack/slot/module/port and a slash between
values is required as part of the notation.
◦
rack : Chassis number of the rack.
◦
slot : Physical slot number of the modular
services card or line card.
◦
module : Module number. A physical
layer interface module (PLIM) is always
0.
◦
port : Physical port number of the
interface.
In references to a Management
Ethernet interface located on a route
processor card, the physical slot
number is alphanumeric ( RSP0 RP0
or RP1 ) and the module is CPU0.
Example: interface MgmtEth0/ RSP0
RP1 /CPU0/0.
Note
•
Virtual interface instance. Number range varies
depending on interface type.
For more information about the syntax for the router,
use the question mark (?) online help function.
interface-path-id
Attaches the specified policy map to the input
interface.
input
Attaches the specified policy map to the output
interface.
output
Specifies the host-linkhost-link
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
134 OL-23235-03
Quality of Service Commands on the Cisco IOS XR Software
show qos interface
To Next Page
Loading...
Need help?
General
