(Optional) Displays detailed QoS information for the
designated node. The node-id argument is entered
in the rack/slot/module notation.
location node-id
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 2.0
L2VPN QoS policy configuration sample output was added.Release 3.4.1
The pre-decrypt, post-decrypt, post-encrypt, and pre-decrypt keywords
were removed.
Release 3.5.0
The command output now includes the following:
•
User-configured values are shown in parentheses.
•
Guaranteed service rate value.
•
Weight for each class.
Release 3.6.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The show qos interface command displays configuration for all classes in the service policy that is attached
to an interface.
Use this command to check the actual values programmed in the hardware from the action keywords in the
police rate command.
Task ID
OperationsTask ID
readqos
Examples
This is the sample output shows the L2VPN QoS information on a GigabitEthernet interface:
RP/0/RP0/CPU0:router# show qos interface GigabitEthernet 0/2/0/0 output
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 135
Quality of Service Commands on the Cisco IOS XR Software
show qos interface
To Next Page
Loading...
Need help?
General
