RP/0/RP0/CPU0:router(config-pmap-c-police)# conform-action set mpls experimental imp 1
RP/0/RP0/CPU0:router(config-pmap-c-police)# conform-action set qos-group 1
RP/0/RP0/CPU0:router(config-pmap-c-police)# exit
RP/0/RP0/CPU0:router(config-pmap-c)# exit
RP/0/RP0/CPU0:router(config-pmap)# exit
RP/0/RP0/CPU0:router(config)# interface gigabitethernet 0/1/0/9
RP/0/RP0/CPU0:router(config-if) service-policy input policy1
Related Commands
DescriptionCommand
Prevents the parent policer from dropping any ingress traffic that conforms
to the maximum rate specified in the child policer.
child-conform-aware
(Used for SIP 700 cards only.) Configures preclassification of ingress
Layer 2 Frame Relay packets that have been previously marked as not
conform-color
discard eligible on an upstream node. These previously-marked packets
are analyzed and preclassified by the color-aware policer on the ingress
interface as part of the 2-rate 3-color (2R3C) traffic policing feature.
Configures the action to take on packets that exceed the rate limit.exceed-action, on page 23
Configures traffic policing and enters policy map police configuration
mode.
police rate, on page 63
Creates or modifies a policy map that can be attached to one or more
interfaces to specify a service policy.
policy-map, on page 67
Displays policy configuration information for all classes configured for
all service policies on the specified interface.
show policy-map interface, on
page 125
Configures the action to take on packets that violate the rate limit.violate-action, on page 144
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 19
Quality of Service Commands on the Cisco IOS XR Software
conform-action
To Next Page
Loading...
Need help?
General
