configure the shaper granularity to 64 kbps. Because 320 is a multiple of 64, the shaper rate will be exactly
320 kbps.
If the shape granularity is not configured, a default value of 256 kbps is applied to all output interfaces
belonging to a particular line card. If the shape granularity is configured using the hw-module qos output
shape granularity location command, but the granularity argument is not specified, a shape granularity of
64 kbps will be configured at the specified location.
Using this command does not affect the ingress shaping granularity for the line card.
Task ID
OperationTask ID
read, writeroot-lr
Examples
This example shows how to set the shape granularity to 128 kbps on the output interface at location 0/1/CPU0:
(config)# hw-module qos output shape granularity 128 location 0/1/CPU0
Examples
This example demonstrates how a default shape granularity of 64 kbps is configured on an interface, when
the granularity argument is not specified. After performing this configuration step, a shape granularity of
64 kbps is applied on the output interface at location 0/1/CPU0:
(config)# hw-module qos output shape granularity location 0/1/CPU0
Related Commands
DescriptionCommand
Displays shape granularity information.show hw-module qos output shape granularity location,
on page 123
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 31
Quality of Service Commands on the Cisco IOS XR Software
hw-module qos output shape granularity location
To Next Page
Loading...
Need help?
General
