Cisco D9800 Configuration Guide

Configuring MPEG over IP or IP Data Streams
Step 1
Do one of the following:
•
Web GUI (single-stream unit): From the D9800 web GUI, choose Transport Stream > MPEG over IP Output
> Stream tab.
•
Front Panel (single-stream unit): From the Main Menu of the D9800 front panel, choose Setup > Outputs > TS
Out > MOIP > MOIP Streams.
•
Web GUI (multi-stream unit): From the D9800 web GUI, choose Transport Stream > IP Data 1/Data 2 or IP
Data 3/Data 4 Output > Stream tab.
•
Front Panel (multi-stream unit): From the Main Menu of the D9800 front panel, choose Setup > Outputs > TS
Out > IP > Streams Configuration.
Step 2
Double-click the stream you want to edit, or from the ID front panel menu, choose the stream you want to edit. A
single-stream unit has up to 16 streams, and a multi-stream unit has up to 32 streams.
If the Output Mode is set to No Output, Passthrough, Service Channels Only, MAP Passthrough, MAP Service Channels
Only, or Transcoding, you can configure the Multi Program Transport Stream (MPTS). PE2 to PE16 or PE32 are not
applicable.
If the Output Mode is set to SPTS Service Channels Only, SPTS MAP Service Channels Only, or SPTS Transcoding,
you can configure PE1 to PE16 or PE32 streams. Each PE creates its own transport stream for the assigned service
channel and ES PIDs.
Step 3
From the Bitrate field, or the User Rate front panel menu, enter the output rate of the transport stream, in Mbps.
Step 4
From the Encapsulation drop-down list, or the MOIP front panel menu, choose the transport protocol to use for the
output stream (UDP or RTP).
Step 5
In the Destination IP field, or the DestAddr front panel menu, enter the unicast (valid host IP only) or multicast
destination IP address.
Step 6
In the Destination UDP Port field, or the UDPPort front panel menu, choose the destination port number (1024 to
65534).
If Encapsulation is set to RTP, you must choose an even destination port number.Note
Step 7
Apply the changes.
Configuring Advanced MPEG over IP or IP Data Stream Settings
Step 1
Do one of the following:
•
Web GUI (single-stream unit): From the D9800 web GUI, choose Transport Stream > MPEG over IP Output
> Stream tab.
Cisco D9800 Network Transport Receiver Version 3.01 Installation and Configuration Guide
25
Configuring the Transport Stream Information
Configuring MPEG over IP or IP Data Streams

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English