Cisco Firepower 2100 Series Hardware Installation Guide

21402130
< 15 A at -48 V
The power supply module is rated at 15 A but the system
power is limited to 6.1 A. See Hardware Specifications, on
page 33 for more system specifications.
Note
Maximum input current
350 WMaximum output power
1+1 redundancy with dual power supply modulesRedundancy
> 88% at 50% loadEfficiency
Power Supply Module LEDs
The following figure shows the bicolor power supply LEDs on the power supply module. The figure shows
the AC power supply module. The DC power supply module has the same LEDs.
Figure 19: Power Supply Module LEDs
Green OK LED2Amber FAIL LED1
The following describes the power module supply LEDs.
Green LED (OK Status)
• Off—Input power not present.
• Green, flashing—Input power present, but system is not powered up (power switch is off).
• Green—The power supply module is enabled and running.
Amber LED (Fail Status)
• Off—No fault detected.
Cisco Firepower 2100 Series Hardware Installation Guide
29
Overview
Power Supply Modules

Cisco Firepower 2100 Series Specifications

General

Brand	Cisco
Model	Firepower 2100 Series
Category	Firewall
Language	English