Cisco Firepower 9300 User Manual

Cisco Preparative Procedures & Operational User Guide
© 2016 Cisco Systems, Inc. All rights reserved.
4 Assurance Activity Configuration
This section has the required guidance and settings as specified in the NDcPP.
4.1 Logging into the Appliance
4.1.1 Log In or Out of the Firepower Chassis Manager
1) To log in to the Firepower Chassis Manager:
a. Using a supported browser, enter the following URL in the address bar:
https://<chassis_mgmt_ip_address>
where <chassis_mgmt_ip_address> is the IP address or host name of the FXOS chassis
that you entered during initial configuration.
Supported Web Browser
Mozilla Firefox – Version 42 and later
Google Chrome – Version 47 and later
b. Enter your username and password.
NOTE! Observe the password is not displayed.
c. Click Login
The Overview page appears if the authentication was successful.
If authentication fails, access will be denied.
Audit Record:
Creation Time: 2015-07-09T08:20:17.030
User: internal
Session ID: internal
ID: 3330860
Action: Creation
Description: Fabric A: local user admin logged in from 172.23.33.113
Affected Object: sys/user-ext/sh-login-admin-pts_5_1_15135
Trigger: Session
Modified Properties: id:pts_5_1_15135, name:admin, policyOwner:local

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes