EasyManuals Logo

Cisco Firepower 9300 User Manual

Cisco Firepower 9300
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
Cisco Preparative Procedures & Operational User Guide
© 2016 Cisco Systems, Inc. All rights reserved.
4.5.7 Logical Device Management
When you create a logical device, the FXOS chassis supervisor deploys the logical device by
downloading the specified software version and pushing the bootstrap configuration and management
interface settings to the specified security module/engine, or in the case of an intra-chassis cluster, to all
security modules installed in the Firepower chassis.
4.5.7.1 Create a ASA Logical Device via CLI
You can create a standalone logical device for each security module/engine installed in the FXOS chassis.
1) Enter security services mode:
Firepower# scope ssa
2) Create the logical device:
Firepower /ssa # create logical-device device_name asa slot_id standalone
3) Enter a description for the logical device:
Firepower /ssa/logical-device* # set description "logical device
description"
4) Assign the management and data interfaces to the logical device:
Firepower /ssa/logical-device* # create external-port-link name
interface_name asa
Firepower-chassis /ssa/logical-device/external-port-link* # exit
5) Configure the management bootstrap information:
a) Create bootstrap object:
Firepower /ssa/logical-device* # create mgmt-bootstrap asa
b) Create enable password:
Firepower /ssa/logical-device/mgmt-bootstrap* # create bootstrap-key-
secret PASSWORD
c) Set password value:
Firepower /ssa/logical-device/mgmt-bootstrap/bootstrap-key-secret* # set
value
Value: password
d) Exit password configuration scope:
Firepower /ssa/logical-device/mgmt-bootstrap/bootstrap-key-secret* # exit
e) Configure management IP address:
Firepower /ssa/logical-device/mgmt-bootstrap* # create ipv4 slot_id
default
f) Set gateway address:
Firepower /ssa/logical-device/mgmt-bootstrap/ipv4* # set gateway
gateway_address
g) Set IP address and mask:

Table of Contents

Other manuals for Cisco Firepower 9300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Firepower 9300 and is the answer not in the manual?

Cisco Firepower 9300 Specifications

General IconGeneral
ChassisModular
Security ModulesUp to 3
Firewall ThroughputUp to 1.2 Tbps
ManagementCisco Firepower Management Center
Form FactorRack-mountable
Number of Slots3
Encryption ThroughputUp to 100 Gbps
Operating Temperature32 to 104°F (0 to 40°C)
Humidity10% to 90% non-condensing
AltitudeUp to 10, 000 ft
Power SupplyDual, hot-swappable
Product TypeSecurity Appliance
Supported ModulesSecurity, network, and interface modules
RedundancyYes

Related product manuals