Cisco Firepower 9300 User Manual

Cisco Preparative Procedures & Operational User Guide
© 2016 Cisco Systems, Inc. All rights reserved.
NOTE! After changing the management IP address, you will need to reestablish any
connections to Firepower Chassis Manager or the FXOS CLI using the new address.
Changing the Application Management IP
You can change the management IP address on the application(s) attached to your FXOS chassis from the
FXOS CLI. To do so, you must first change the IP information at the FXOS platform level, then manually
propagate the changes to the application level.
1) Connect to the FXOS CLI.
2) Scope the security module:
scope slot slot_number
3) Configure the new management bootstrap parameters.
set virtual ip ip_address mask network_mask gateway gateway_ip_address
For clustered configuration:
set virtual ip ip_address pool start_ip end_ip mask network_mask gateway
gateway_ip_address
4) Scope the application.
scope app-instance asa_or_ftd
5) Clear the management bootstrap information.
clear mgmt-bootstrap
6) Exit management bootstrap configuration scope.
Exit
7) Commit the configuration:
commit-buffer
8) Connect to the console of the security module.
9) Change the virtual IP, mask, and gateway values to the exact values used in step 3.
set virtual ip ip_address netmask network_mask gw gateway_ip_address
For clustered configuration:
set virtual ipv ip_address pool start_ip end_ip mask network_mask gateway
gateway_ip_address
10) Commit the configuration:
commit-buffer

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes