Cisco Firepower 9300 User Manual

Cisco Preparative Procedures & Operational User Guide
© 2016 Cisco Systems, Inc. All rights reserved.
1) Enter system mode:
Firepower-chassis# scope system
2) Enter system services mode:
Firepower-chassis /system # scope services
3) Configure the system clock:
Firepower-chassis /system/services # set clock month day year hour min sec
For month, use the first three digits of the month. Hours must be entered using the 24-hour format,
where 7 pm would be entered as 19.
System clock modifications take effect immediately. You do not need to commit the buffer.
Set the Date and Time Manually via GUI
1) Choose Platform Settings > NTP.
2) Click the Time Synchronization tab.
3) Under Set Time Source, click Set Time Manually.
4) Click the Date drop-down list to display a calendar and then set the date using the controls available
in the calendar.
5) Use the corresponding drop-down lists to specify the time as hours, minutes, and AM/PM.
6) Click Save.

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes