Enhanced Digital Return (EDR) System Installation
Installing the EDR Receiver
Refer to the Cisco Prisma II EDR Receiver Installation Guide, part number 4044294,
for detailed information on installing the EDR receiver module on the Prisma II.
To Install the OPM Module on the Receiver Module
The following diagram shows the OPM module installed on the receiver module of
the Prisma II.
To Configure the Receiver Mode
The receiver mode can be configured in the Web UI interface though connection
with the Prisma II platform.
For complete configuration steps and setup precautions, refer to the Cisco Prisma II
EDR Receiver Installation Guide, part number OL-29646, and the Cisco Prisma II
Platform Configuration Guide, after system release 2.05.30, part number OL-27998.
To Next Page
Loading...
