Cisco ISA 3000 Hardware Installation Guide

CHAPTER
2-25
Cisco ISA 3000 Industrial Security Appliance Hardware Installation Guide
2
Installing the Cisco ISA 3000 Industrial
Security Appliance
This chapter describes the equipment and the procedures for successfully installing the Cisco ISA 3000
and contains the following sections:
• Equipment, Tools, and Connections, page 2-26
• Installing the Cisco ISA 3000, page 2-26
Warning Read the installation instructions before connecting the system to the power source. Statement
1004
Warning Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
requirements in IEC 60950 based safety standards. Statement 1033
Warning Only trained and qualified personnel should be allowed to install, replace, or service this
equipment. Statement 1030
Warning The covers are an integral part of the safety design of the product. Do not operate the unit
without the covers installed. Statement 1077
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment
in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
Statement 1024
Note When cleaning external surfaces, use a dry, non-static cloth.

Cisco ISA 3000 Specifications

General

Brand	Cisco
Model	ISA 3000
Category	Security System
Language	English