2-26
Cisco ISA 3000 Industrial Security Appliance Hardware Installation Guide
Chapter 2 Installing the Cisco ISA 3000 Industrial Security Appliance
Equipment, Tools, and Connections
Equipment, Tools, and Connections
This section describes the equipment, tools, and connections necessary for installing your Cisco ISA
3000. It contains the following topics:
• Items Shipped with your Cisco ISA 3000, page 2-26
• Additional Items, page 2-26
• Ethernet Devices, page 2-26
Items Shipped with your Cisco ISA 3000
Unpack the box and verify that all items listed on the invoice were shipped with the Cisco ISA 3000.
The following items are shipped with your device:
• Product Document Of Compliance (PDOC) Part Number 78-100733-01
• Alarm Connector
• Two Power Connectors
Additional Items
The following items are not shipped with the device but are required for installation:
• ESD-preventive cord and wrist strap.
• Wire crimper for chassis grounding.
• Wire for connecting the chassis to an earth ground.
• AWG 14 (2 mm²) or larger wire for NEC-compliant chassis grounding.
• Ethernet cables for connecting to the Gigabit Ethernet ports.
• Fiber optic cables and SFP transceivers for connecting to fiber LAN ports.
• Ratcheting torque flathead screwdriver that exerts up to 15 in-lb (1.69 N-m) of pressure.
• A number-2 Phillips screwdriver.
Ethernet Devices
Identify the Ethernet devices that you will connect to the device: hub, servers, and workstations or PCs.
Ensure that each device has a network interface card (NIC) for connecting to Ethernet ports.
If you plan to configure the software through the console port, provide an ASCII terminal or a PC that
is running terminal emulation software to connect to the console port.
Installing the Cisco ISA 3000
This section describes how to install the Cisco ISA 3000. This device can be installed on a table top or
other flat horizontal surface mounted on a wall or DIN rail.
To Next Page
Loading...
Need help?
General
