Supporting such capabilities on the field-replaceable feature card allows you to upgrade the
LightStream 1010 in the field as and when such standards evolve and more advanced mechanisms
are required.
Note When you upgrade the feature card you must power down the switch and remove the ASP
module.
Specifications
Table 3 lists the ATM switch processor specifications:
Table 3 ATM Switch Processor Module Specifications
1. Gbps = gigabits per second
Description Specifications
Switch and processor
capacity
5 Gbps
1
shared memory, nonblocking switch fabric
65,536 cells of ATM cell buffers
Software images Default image with IISP protocol
Optional PNNI image with plug-and-play capacity
Dimensions (H x W x D) 1.2 x 14.4 x 16 in.(3.0 x 36.6 x 40.6 cm)
Weight 6.85 lb (3.09 kg)
Operating temperature 32 to 104F (0 to 40C)
Nonoperating temperature -40 to 67F (-40 to 75C)
Humidity 10 to 90%, noncondensing
Altitude -500 to 10,000 ft (-52 to 3,048 m)
Microprocessor 100-MHz MIPs R4600
Memory 8 MB of Flash memory (upgradeable to 16 MB)
16 MB of packet-buffer DRAM
2
standard (upgradeable to 64 MB)
256 KB of boot EPROM
128 KB of SRAM
3
Interface timing Loop timing, Stratum 4 accuracy clock for self-timing, master clock distribution port
ATM Switch Processor
(ASP)
ASP module, 16 MB DRAM, 8 MB Flash memory, No Flash card installed
WATM-ASP1
Management access Standard Ethernet and dual EIA/TIA 232 serial ports on ASP module
ASP Interface ports RJ-45 IEEE 802.3 Ethernet 10BaseT port, 25-pin EIA/TIA-232
4
AUX port, and a
DB-25 console port for an administration workstation
Network management Port Tx and Rx LEDs, switch and common equipment status LEDs
Mean Time Between
Failures
5.8 years for ASP and Feature card
Maximum
station-to-station cabling
distance
10BaseT Ethernet—Category 3-5 UTP
5
: 328 ft. (100 m)
Agency approvals Safety: UL
6
1950, CSA
7
-C22.2 No. 950-93, and EN60950
EMI
8
: FCC Class A
CE Mark, and VCCI Class II with shielded cables