Linksys E4200
RADIUS
Disabled
Chapter 2: Advanced Configuration
This option features WEP used in coordination with a
RADIUS server . (This should only be used when a RADIUS
server is connected to the router .)
NOTE: If you select RADIUS as your Security
Mode, each device in your wireless network
MUST use RADIUS and the same encryption
and shared key .
If you choose to disable wireless security, you will be
informed that wireless security is disabled when you first
attempt to access the Internet . You will given the option to
enable wireless security, or confirm that you understand
the risks but still wish to proceed without wireless security .
NOTE: When wireless security is disabled,
anyone can access your wireless network at any
time .
Wireless Security > Disabled
Wireless Security > RADIUS
RADIUS Server Enter the IP address of the RADIUS server .
RADIUS Port Enter the port number of the RADIUS
server . The default is 1812 .
Shared Secret Enter the key shared between the router
and the server .
Encryption Select a level of WEP encryption, (40/64-bit
10 hex digits) or 104/128-bit (26 hex digits) . The default
is 40/64-bit (10 hex digits) .
Passphrase Enter a passphrase to automatically generate
WEP keys . Then click Generate .
Key 1-4 If you did not enter a passphrase, enter the WEP
key(s) manually .
TX Key Select a default TX (Transmit) Key to use . The
default is 1 .
Maximum Performance Wireless-N Router
17
To Next Page
Loading...
Need help?
General
