Cisco Linksys E4200

Linksys E4200
WPA2 Enterprise
This option features WPA2 used in coordination with a
RADIUS server . (This should only be used when a RADIUS
server is connected to the router .)
NOTE: If you select WPA2 Enterprise as your
Security Mode, each device in your wireless
network MUST use WPA2 Enterprise and the
same shared key .
Chapter 2: Advanced Configuration
RADIUS Server Enter the IP address of the RADIUS server .
RADIUS Port Enter the port number of the RADIUS
server . The default is 1812 .
Shared Key Enter the key shared between the router and
the server .
WEP
WEP is a basic encryption method, which is not as secure
as WPA .
NOTE: If you select WEP as your Security Mode,
each device in your wireless network MUST use
WEP and the same encryption and shared key .
Wireless Security > WPA2 Enterprise
RADIUS Server Enter the IP address of the RADIUS server .
RADIUS Port Enter the port number of the RADIUS
server . The default is 1812 .
Shared Key Enter the key shared between the router and
the server .
WPA Enterprise
This option features WPA used in coordination with a
RADIUS server . (This should only be used when a RADIUS
server is connected to the router .)
NOTE: If you select WPA Enterprise as your
Security Mode, each device in your wireless
network MUST use WPA Enterprise and the
same shared key .
Wireless Security > WEP
Encryption Select a level of WEP encryption, (40/64-bit
10 hex digits) or 104/128-bit (26 hex digits) . The default
is 40/64-bit (10 hex digits) .
Passphrase Enter a passphrase to automatically generate
WEP keys . Then click Generate .
Key 1-4 If you did not enter a passphrase, enter the WEP
key(s) manually .
TX Key Select a default TX (Transmit) Key to use . The
default is 1 .
Wireless Security > WPA Enterprise
Maximum Performance Wireless-N Router
16