Phone Adapter with 2 Ports for Voice-over-IP
11
Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu
Using the Interactive Voice Response Menu
Check DHCP 100 Use this command to find out if DHCP
has been enabled or disabled. If
enabled, the Phone Adapter will be
automatically assigned an IP address
by your network router or gateway. If
disabled, then the Phone Adapter will
use a static IP address.
Enable/Disable DHCP 101 Enter 1 to enable
Enter 0 to disable
Enable or disable the Phone Adapter’s
DHCP feature. If your network router
or gateway assigns IP addresses, then
enter 1. Otherwise, enter 0.
Check IP Address 110 You will hear the current IP address of
the Phone Adapter.
Interactive Voice Response Menu
Action Command
(press these
keys on the
telephone)
Choices Description
To Next Page
Loading...
Need help?
General