Cisco Linksys PAP2 User Manual

Phone Adapter with 2 Ports for Voice-over-IP
12
Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu
Using the Interactive Voice Response Menu
Set Static IP Address 111 Enter the IP
address using
numbers on the
telephone keypad.
Use the * (star) key
when entering a
decimal point.
To set a static IP address, the DHCP
feature must be disabled. If the DHCP
feature is enabled, then you will hear,
“Invalid Option,” if you try to set a
static IP address.
Check Network Mask
(or Subnet Mask)
120 You will hear the current network
mask of the Phone Adapter.
Set Network Mask (or
Subnet Mask)
121 Enter the network
mask using
numbers on the
telephone keypad.
Use the * (star) key
when entering a
decimal point.
To set the network mask, the DHCP
feature must be disabled. If the DHCP
feature is enabled, then you will hear,
“Invalid Option,” if you try to set the
network mask.
Check Static Gateway
IP Address
130 You will hear the current gateway IP
address of the Phone Adapter.
Interactive Voice Response Menu
Action Command
(press these
keys on the
telephone)
Choices Description

Cisco Linksys PAP2 Specifications

General

Brand	Cisco
Model	Linksys PAP2
Category	Adapter
Language	English