2-25
Cisco MDS 9148S Multilayer Switch Hardware Installation Guide
OL-20185-01
Chapter 2 Installing the Cisco MDS 9148S Switch
Installing the Switch in a Cabinet with Insufficient Front Clearance
Step 4 Stabilize the switch in the rack by attaching the front rack-mount brackets to the rear rack-mounting
rails:
a. Insert two screws (12-24 or 10-32, depending on rack type) through the holes in one of the front
rack-mount brackets and into the threaded holes in the back rack-mounting rail (see Figure 2-4). For
racks with square holes, first install the 12-24 cage nuts.
Figure 2-4 Attaching the Cisco MDS 9148S Switch (Rear-Facing) to the Cabinet
b.
Repeat for the front rack-mount bracket on the other side of the switch.
Tip If the chassis exceeds the 1-RU space on the low side of the rack, you may have difficulty installing other
equipment. In this situation, loosen the screws on the front and back rails of the chassis and raise it to
the top of the RU space by pushing the chassis up until it cannot go any further. Then retighten the screws
while keeping the chassis in the elevated position.
182464
Front cabinet
mounting
rails
Rear cabinet
mounting
rails
To Next Page
Loading...
