Solid orange
Power is applied but the appliance is not connected to
the Meraki Dashboard
Rainbow Colors
The appliance is attempting to connect to Meraki
Dashboard
Flashing White Firmware upgrade in progress
Solid White
Fully operational/connected, uplink actively using wired
WAN
Solid Purple (Z3C only)
Fully operational/connected, uplink actively using
cellular failover
Back Panel
Z3
Additional functions on the back panel are described below, from left to right.
USB port
USB 3.0 for 3G/4G wireless cards. Traffic status is
indicated by the USB LED.
Reset button
Insert a paper clip if a reset is required.
• Press for 1 second to delete a downloaded
configuration and reboot.
• Press and hold for more than 10 seconds to force a
full factory reset.
WAN / Internet port
[Far left Ethernet port] This port provides connectivity to
the WAN.
LAN ports
These 4 ports provide connectivity to computers,
6
To Next Page
Loading...
