Cisco NCS 1001 - Page 33

Each EDFA module pluggable within Cisco NCS1001 slot contains two optical amplifiers such as a booster
and a pre-amplifier. The list of components applicable as amplifier name is listed in the following table:
Naming ConventionComponent
0/S-AMP-PREEDFA Module, Pre-Amplifier
0/S-AMP-BSTEDFA Module, Booster Amplifier
Openconfig Protection Switching Model
The following is the tree structure of Transport Line Protection model:
module: openconfig-transport-line-protection
+--rw aps
+--rw aps-modules
+--rw aps-module* [name]
+--rw name -> ../config/name
+--rw config
| +--rw name? -> /oc-platform:components/component/name
| +--rw primary-switch-threshold? decimal64
| +--rw secondary-switch-threshold? decimal64
+--ro state
| +--ro name? -> /oc-platform:components/component/name
| +--ro primary-switch-threshold? decimal64
| +--ro secondary-switch-threshold? decimal64
| +--ro active-path? identityref
+--rw ports
+--rw line-primary-in
| +--rw config
| | +--rw target-attenuation? decimal64
| +--ro state
| +--ro target-attenuation? decimal64
| +--ro attenuation? decimal64
| +--ro optical-power
| +--ro instant? decimal64
| +--ro avg? decimal64
| +--ro min? decimal64
| +--ro max? decimal64
+--rw line-primary-out
| +--rw config
| | +--rw target-attenuation? decimal64
| +--ro state
| +--ro target-attenuation? decimal64
| +--ro attenuation? decimal64
| +--ro optical-power
| +--ro instant? decimal64
| +--ro avg? decimal64
| +--ro min? decimal64
| +--ro max? decimal64
+--rw line-secondary-in
| +--rw config
| | +--rw target-attenuation? decimal64
| +--ro state
| +--ro target-attenuation? decimal64
| +--ro attenuation? decimal64
| +--ro optical-power
| +--ro instant? decimal64
| +--ro avg? decimal64
| +--ro min? decimal64
| +--ro max? decimal64
+--rw line-secondary-out
Data Models Configuration Guide for Cisco NCS 1001
29
Configuring NCS 1001 Using OpenConfig Data Model
Openconfig Protection Switching Model