cep is configured: TRUE cem_id :10
Configured Loopback : Locally Looped
Use the show controller sonet 0/0/8 command to verify the path level network loopback configuration on VCoP smart SFP.
SONET 0/0/8 is up.
Hardware is A900-IMA8S
Port configured rate: OC3
Applique type is Channelized Sonet/SDH
Clock Source is Line
....
......
.........
SONET/SDH Path Tables
INTERVAL CV ES SES UAS
02:35-02:35 0 0 0 0
STS-1 1 mode UNFRAMED
cep is configured: TRUE cem_id :10
Configured Loopback : Network Looped
Configuring Loopback on SONET Controller
Configuring Network Loopback
Follow these steps to configure network loopback on sonet controller.
enable
configure terminal
controller SONET 0/0/8
loopback network
exit
Configuring Local Loopback
Follow these steps to configure local loopback on sonet controller.
enable
configure terminal
controller SONET 0/0/8
loopback local
exit
Verifying Loopback at Controller Level
Use the show controller sonet 0/0/8 command to verify the controller level local loopback configuration on VCoP smart SFP.
SONET 0/0/8 is up.(Configured for Locally Looped)
Hardware is A900-IMA8S
Port configured rate: OC3
Applique type is Channelized Sonet/SDH
.....
......
Use the show controller sonet 0/0/8 command to verify the BERT configuration on VCoP Smart SFP.
SONET 0/0/8 is up.(Configured for Network Looped)
Hardware is A900-IMA8S
Port configured rate: OC3
Applique type is Channelized Sonet/SDH
......
........
22
To Next Page
Loading...
