Cisco NCS 4200 Series - Associated Commands

cem 29
!
cem 30
!
cem 31
!
!
Example: VCoP Smart SFP Configuration on T3
Enabling the VCoP SSFP.
#########################
platform smart-sfp interface gigabitEthernet 0/0/10 type DS3
%DSX-4-ALARM: T3 0/0/10 DS3_RX_RAI: CLEARED
%CONTROLLER-5-UPDOWN: Controller T3 0/0/10, changed state to up
%LINK-3-UPDOWN: Interface T3 0/0/10, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface T3 0/0/10, changed state to up
configuring the t3 controller.
=============================
controller t3 0/0/10
cem-group 0 cep
%LINEPROTO-5-UPDOWN: Line protocol on Interface CEM0/0/10, changed state to up
%LINK-3-UPDOWN: Interface CEM0/0/10, changed state to up
cnfiguring the cem interface
##########################
interface cem0/0/10
cem 0
xconnect 2.2.2.2 101 encapsulation mpls
!
Associated Commands
The commands used to configure VCoP Smart SFP.
URLCommands
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/interface/
command/ir-cr-book/ir-o1.html#wp2283539401
platform smart-sfp
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/interface/
command/ir-cr-book/ir-c2.html#wp2020468554
controller sonet
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/interface/
command/ir-cr-book/ir-f1.html#wp6807068490
framing sonet
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/interface/
command/ir-cr-book/ir-c2.html#wp1921350260
controller t3
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/interface/
command/ir-cr-book/ir-s6.html#wp2423232697
sts-1
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/interface/
command/ir-cr-book/ir-c1.html#wp2440628600
cem-group
26