Cisco NCS 4200 Series - Page 6

mode unframed
cem-group 20 cep
sts-1 2
mode unframed
cem-group21 cep
sts-1 3
mode unframed
cem-group 22 cep
exit
Configuring CEM Circuits on VCoP for STS-3c on OC-3
enable
configure terminal
controller SONET 0/0/10
framing sonet
sts-1 1-3 mode sts-3c
cem-group 0 cep
overhead c2 0
exit
Configuring Cross-connect for STS-1 on OC-3
Ensure that the VC number configured in xconnect command is the same on both PEs.Note
enable
configure terminal
interface CEM0/0/8
no ip address
cem 20
xconnect 2.2.2.2 3000 encapsulation mpls
cem 21
xconnect 2.2.2.2 3001 encapsulation mpls
cem 22
xconnect 2.2.2.2 3002 encapsulation mpls
exit
Configuring Cross-connect for STS-3C on OC-3
enable
configure terminal
interface GigabitEthernet0/0/10
no ip address
negotiation auto
interface CEM0/0/10
no ip address
cem 0
xconnect 2.2.2.2 1000 encapsulation mpls
exit
Verifying VCoP Smart SFP Configuration for STS-1 on OC-3
Use the show cem circuit command to verify the VCoP smart SFP configuration.
Device# show cem circuit detail
CEM0/0/8, ID: 20, Line: UP, Admin: UP, Ckt: ACTIVE
Controller state: up, CEP state: up
Idle Pattern: 0xFF, Idle CAS: 0x8
Dejitter: 5 (In use: 0)
Payload Size: 783
Framing: Unframed
6