BER monitoring:
Not supported
Forward error correction: Standard (Reed-Solomon)
Holdoff Time: 3000ms
Enabling Idle Insertion on OTN-XP Card
From R7.2.1 onwards, you can enable the idle insertion feature on the 10GE controller for OTN-XP card.
To enable idle insertion on the 10GE controller, enter the following commands:
configure
controller tenGigECtrlr Rack/Slot/Instance/Port/Lanenumber
holdoff-time trunk-fault time-value
commit
The range of Lanenumber is from 1 to 4 and the range of holdoff-time trunk-fault time-value is from 0 to 3000
ms.
The following is a sample for enabling the idle insertion feature in 10GE controllers:
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller tenGigECtrlr 0/0/0/4/1
RP/0/RP0/CPU0:ios(config-eth-ctrlr)#holdoff-time trunk-fault 2000
RP/0/RP0/CPU0:ios(config-eth-ctrlr)#commit
To view the hold-off time that is configured on 10GE controllers, use the following command:
show controllers tenGigECtrlr Rack/Slot/Instance/Port/Lanenumber
Example
RP/0/RP0/CPU0:ios#show controllers TenGigECtrlr 0/0/0/4/1
Thu Mar 26 12:46:16.543 UTC
Operational data for interface TenGigECtrlr0/0/0/4/1:
State:
Administrative state: enabled
Operational state: Up
LED state: Green On
Maintenance: Disabled
AINS Soak: None
Total Duration: 0 hour(s) 0 minute(s)
Remaining Duration: 0 hour(s) 0 minute(s) 0 second(s)
Laser Squelch: Disabled
Phy:
Media type: Not known
Autonegotiation disabled.
Operational values:
Speed: 10Gbps
Duplex: Full Duplex
Flowcontrol: None
Loopback: None (or external)
Inter-packet gap: standard (12)
BER monitoring:
Not supported
Holdoff Time: 2000ms
Configuring Controllers
20
Configuring Controllers
Enabling Idle Insertion on OTN-XP Card
To Next Page
Loading...
