Cisco NCS1004 - Configuring Laser Squelching on OTN-XP Card

Forward error correction: Standard (Reed-Solomon)
Holdoff Time: 0ms
Configuring Laser Squelching on OTN-XP Card
From R7.2.1 onwards, laser squelching is supported on 10GE controllers for the OTN-XP card.
To configure laser squelching on the 10GE controllers for the OTN-XP card, use the following commands:
configure
controller tenGigECtrlr Rack/Slot/Instance/Port/Lanenumber
laser-squelch
commit
The range of Lanenumber is from 1 to 4.
The following is a sample where laser squelching is enabled on the 10GE controller for the OTN-XP card.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller tenGigECtrlr 0/0/0/4/1
RP/0/RP0/CPU0:ios(config-eth-ctrlr)#laser-squelch
RP/0/RP0/CPU0:ios(config-eth-ctrlr)#commit
The following is a sample to view the laser squelch status on the 10GE controller.
P/0/RP0/CPU0:ios#show controllers tenGigECtrlr 0/0/0/4/1
Wed May 6 06:28:29.603 UTC
Operational data for interface TenGigECtrlr0/0/0/4/1:
State:
Administrative state: enabled
Operational state: Up
LED state: Red On
Maintenance: Disabled
AINS Soak: None
Total Duration: 0 hour(s) 0 minute(s)
Remaining Duration: 0 hour(s) 0 minute(s) 0 second(s)
Laser Squelch: Enabled
Phy:
Media type: Not known
Autonegotiation disabled.
Operational values:
Speed: 10Gbps
Duplex: Full Duplex
Flowcontrol: None
Loopback: None (or external)
Inter-packet gap: standard (12)
BER monitoring:
Not supported
Holdoff Time: 0ms
Configuring Controllers
18
Configuring Controllers
Configuring Laser Squelching on OTN-XP Card