Corporate Headquarters:
Copyright © 2004 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Power Up and Initial Configuration Procedures
for Cisco 2800 Series Routers
This document describes how to power up your Cisco 2800 series integrated services router and perform
an initial configuration to provide network access. It includes the following sections:
• Powering Up Cisco 2800 Series Routers, page 1
• Configuring the Router, page 4
Powering Up Cisco 2800 Series Routers
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement
1029
This section covers the following topics:
• Checklist for Power Up, page 1
• Power Up Procedure, page 2
• Verifying the Front Panel LED Indications, page 3
• Verifying the Hardware Configuration, page 4
Checklist for Power Up
You are ready to power up the Cisco router if the following steps are completed:
• Chassis is securely mounted and grounded.
• Power and interface cables are connected.
To Next Page
Loading...
Need help?
General
