9
Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers
OL-5788-01
Configuring the Router
Verifying the Initial Configuration
Verify that the new interfaces are operating correctly by performing the following tests:
• To verify that the interfaces are operating correctly and that the interfaces and line protocol are in
the correct state—up or down—enter the show interfaces command.
• To display a summary status of the interfaces configured for IP, enter the show ip interface brief
command.
• To verify that you configured the correct hostname and password, enter the show configuration
command.
When you have completed and verified the initial configuration, your Cisco router is ready to configure
for specific functions. See the “Completing the Configuration” section on page 9 for information about
locating documentation for advanced configuration procedures.
Completing the Configuration
When you have completed and verified the initial configuration, your Cisco router is ready to configure
for specific functions. For advanced configuration procedures, use either SDM or the CLI.
For configuration procedures using SDM, refer to the Cisco Router and Security Device Manager (SDM)
Quick Start Guide that shipped with your router.
For configuration procedures using the CLI, refer to the online Cisco 2800 series software configuration
documents. The software configuration documents include information about the following topics:
• Basic software configuration
• Feature documentation
• Configuration examples
• Troubleshooting and maintenance
• Cisco 2800 series cards and modules
To Next Page
Loading...
Need help?
General
