Cisco Nexus 1000V - Page 8

Table 1: New and Changed Features for the Cisco Nexus 1000V Interface Configuration Guide
Where DocumentedChanged in ReleaseDescriptionFeature
Configuring Port Channels,
on page 45
4.2(1)SV2(1.1)The interface
level
configuration
mode does
not support
sub-group
cdp and
manual
options for
port-channel
vPC-HM
configuration.
Sub-group
cdp and
manual
options for
port-channel
vPC-HM
configuration
are supported
on the
port-profile
level
configuration.
Port channel vPC-HM
Configuring Port Channels,
on page 45
4.2(1)SV1(4a)You can
assign up to
seven backup
subgroups
when pinning
the primary
subgroup.
Backup subgroups
Configuring Port Channels,
on page 45
4.2(1)SV1(4a)The subgroup
numbering
begins at zero
and is not tied
to the vmnic
number.
Port channel relative
numbering
Configuring Port Channels,
on page 45
4.2(1)SV1(4)Pinpoints link
failures on a
port channel
configured
for vPC-HM.
Network state tracking for
vPC-HM
Cisco Nexus 1000V for VMware vSphere Interface Configuration Guide, Release 5.x
2
New and Changed Information
New and Changed Information