Cisco Nexus 1000V - Page 9

Where DocumentedChanged in ReleaseDescriptionFeature
Configuring Port Channels,
on page 45
4.2(1)SV1(4)You can
offload
operation of
the LACP
protocol from
the VSM to
the VEMs.
VEM management of LACP
Configuring Port Channels,
on page 45
4.2(1)SV1(4)You can
enable the
LACP port
channel
function by
turning on the
feature using
the feature
lacp
command.
LACP
Configuring Interface
Parameters, on page 11
4.2(1)SV1(4)The system
jumbo MTU
value is fixed
at 9000 and
cannot be
changed.
System Jumbo MTU
Configuring Interface
Parameters, on page 11
4.2(1)SV1(4)You can
configure an
interface
MTU
between 1500
and 9000.
Interface MTU
Configuring Virtual Ethernet
Interfaces, on page 35
4.2(1)SV1(4)vEthernet
interfaces are
now mapped
to connected
ports by
MAC
addresses as
well as the
DVPort
number.
Mapping vEthernet interfaces
to connected ports
Cisco Nexus 1000V for VMware vSphere Interface Configuration Guide, Release 5.x
3
New and Changed Information
New and Changed Information