Send documentation comments to nexus5kdocs@cisco.com
2-20
Cisco Nexus 2000 Series Hardware Installation Guide
OL-19013-05
Chapter 2 Using a Fabric Extender with a Cisco Nexus 7000 Series Switch
Cisco Nexus 2232PP FEX
Figure 2-10 on page 2-10 shows the major features of the SFP+ optical transceiver used for uplink
connections. For specifications that apply to these optical transceivers, see the “SFP+ Optical
Transceiver Specifications” section on page B-6.
Figure 2-11 on page 2-10 shows the major features of the SFP+ copper transceiver and cable used for
uplink connections. For the cable specifications that apply to these transceivers, see the “SFP+ Copper
Transceiver Specifications” section on page B-7.
Figure 2-12 on page 2-11 shows the major features of RJ-45 connectors, which are used for the downlink
connections.
Cisco Nexus 2232PP FEX
The Cisco Nexus 2232PP FEX is a stackable 1- and 10-Gigabit FEX that has 32 1- and 10-Gbps Ethernet
host-facing (downlink) SFP or SFP+ ports and eight 10-Gbps Ethernet and Fibre Channel over Ethernet
(FCoE) network-facing (uplink) SFP+ or FET ports. It requires a 19-inch (48.26 cm) rack for its
installation. Table 2-7 lists its physical characteristics.
Table 2-6 Supported Transceivers and Connector for the Cisco Nexus 2232TM FEX Uplink Interfaces
Transceiver or
Connector
Cable
Type
Fabric
Interface
(Uplink)
Host
Interface
(Downlink) Comments
FET-10G Optical X – 10 Gbps FEX transceiver
SFP-10G-LR Optical X – 10 Gbps long range transceiver (up to 6.2 miles [10 km])
SFP-10G-SR Optical X – 10 Gbps Short range transceiver (up to 984 feet [300 m])
SFP -H10GB-CU1M
1
Copper X – 10 Gbps Twinax, passive transceiver (3.3 feet [1 meter])
SFP -H10GB-CU3M Copper X – 10 Gbps Twinax, passive transceiver (9.8 feet [3 meters)
SFP -H10GB-CU5M Copper X – 10 Gbps Twinax, passive transceiver (16.4 feet [5 meters])
SFP -H10GB-ACU7M Copper X – 10 Gbps Twinax, active transceiver (23.0 feet [7 meters])
SFP -H10GB-ACU10M Copper X – 10 Gbps Twinax, active transceiver (32.8 feet [10 meters])
RJ-45 Copper – X 100/1000 Mbps Connector
1. The SFP-H10GB-CUxM transceivers are not supported by the M1 Series 32-port 10-Gigabit Ethernet I/O module (N7K-M132XP-12). These transceivers
are supported by the other Cisco Nexus 7000 Series I/O modules.
Table 2-7 Physical Characteristics for the Cisco Nexus 2232PP FEX
Dimensions
Width
Depth
Height
17.3 inches (43.94 cm)
17.7 inches (44.96 cm)
1.72 inches (4.37 cm)
Weight
1
18.3 lb (8.3 kg)
1. Measured with two power supplies and one fan module installed
To Next Page
Loading...
