Cisco Nexus 9332C User Manual

Cisco Nexus 9332C ACI-Mode Switch Hardware Installation Guide
First Published: 2018-10-24
Last Modified: 2019-03-28
Americas Headquarters
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
http://www.cisco.com
Tel: 408 526-4000
800 553-NETS (6387)
Fax: 408 527-0883

Cisco Nexus 9332C Specifications

General

Brand	Cisco
Model	Nexus 9332C
Category	Switch
Language	English

Summary

Chapter 1 Overview

Overview

Introduction to the Cisco Nexus 9332C switch and its features.

Chapter 2 Preparing the Site

Temperature Requirements

Specifies acceptable operating and non-operating temperature ranges.

Grounding Requirements

Explains the importance and methods for proper switch grounding.

Planning for Power Requirements

Guidance on power supply configurations and redundancy planning.

Airflow Requirements

Specifies requirements for proper airflow and cooling for the switch.

Rack and Cabinet Requirements

Details specifications for compatible racks and cabinets.

Clearance Requirements

Specifies minimum clearances needed around the chassis for installation and airflow.

Chapter 3 Installing the Switch Chassis

Safety

Essential safety precautions to follow before and during installation.

Installation Options with Rack-Mount Kits, Racks, and Cabinets

Airflow Considerations

Installation Guidelines

Installing the Switch Using the NXK-ACC-KIT-1RU Rack-Mount Kit

Step-by-step guide for installing with a specific rack-mount kit.

Installing the Switch Using the N3K-C3064-ACC-KIT Rack-Mount Kit

Step-by-step guide for installing with another rack-mount kit.

Grounding the Chassis

Detailed instructions for grounding the switch chassis.

Starting the Switch

Procedures for powering on and initializing the switch after installation.

Chapter 4 Connecting the Switch to the ACI Fabric

ACI Fabric Topology

Connecting Leaf Switches to APICs

How to connect leaf switches to APIC controllers.

Connecting Leaf Switches to Spine Switches

How to connect leaf switches to spine switches.

Virtual Port Channel Migration - Migration of Nodes from a First-Generation Switch to a Second-Generation Switch

Optic Transceiver Removal Using the Optics Extraction Tool

Chapter 5 Replacing Components

Replacing a Fan Module

Instructions for replacing a fan module while the switch is operating.

Replacing a Power Supply Module

Instructions for replacing a power supply module for redundancy.

Replacing an AC Power Supply

Detailed steps for replacing an AC power supply.

Replacing a DC Power Supply

Detailed steps for replacing a DC power supply.

Appendix B System Specifications

Switch Power Input Requirements

Power Specifications

Regulatory Standards Compliance Specifications