EasyManua.ls Logo

Cisco Nexus 5000 Series - Configuring Per-VLAN Consistency Checks

Cisco Nexus 5000 Series
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Send documentation comments to n5kdocfeedback@cisco.com
1-5
Cisco Nexus 5000 Series NX-OS Interfaces Operations Guide, Release 5.0(3)N2(1)
Chapter 1 Virtual Port Channel Operations
vPC Consistency Checks
This example shows that the vPC ports and the VLANs remain up on the primary switch when an
interface-level Type 1 inconsistency occurs:
Configuring Per-VLAN Consistency Checks
Beginning with Cisco NX-OS Release 5.0(2)N2(1), the Cisco Nexus 5000 Series switch performs
Type-1 consistency checks on a per-VLAN basis when you enable or disable STP on a VLAN. VLANs
that do not pass this consistency check are brought down on the primary and secondary switches while
other VLANs are not affected.
When you enter the no spanning-tree vlan number command on one peer switch, only the specified
VLAN is suspended on both peer switches; the other VLANs remain up.
Note Per-VLAN consistency checks are not dependent on whether graceful consistency checks are enabled.
This example shows the active VLANs before suspending a specified VLAN:

Table of Contents

Other manuals for Cisco Nexus 5000 Series

Related product manuals