Cisco Nexus 9348GC-FX3 - Page 8

• Power supply modules (two—one for operations and one for redundancy [1+1]) with the following
choices (a mix of AC and DC power sources is supported but do not mix airflow directions):
• 350-W AC power supply with port-side intake airflow (burgundy coloring) (NXA-PAC-350W-PI2)
• 350-W AC power supply with port-side exhaust airflow (blue coloring) (NXA-PAC-350W-PE2)
• 350-W PHV power supply with port-side intake airflow (burgundy coloring) (NXA-PHV-350W-PI)
• 350-W PHV power supply with port-side exhaust airflow (blue coloring) (NXA-PHV-350W-PE)
• 440-W DC power supply with port-side intake airflow (burgundy coloring) (NXA-PDC-440W-PI)
• 440-W DC power supply with port-side exhaust airflow (blue coloring) (NXA-PDC-440W-PE)
The 350-W AC power supply does not have the standby voltage to be able to
carry to a second power supply, to allow it to communicate and poll the device.
Note
The following figure shows the switch features on the port side of the chassis.
SFP28 ports (4)2LEDs1
10M/100M/1G RJ45 ports (48)4QSFP28 ports (2)3
To determine which transceivers, adapters, and cables are support this switch, see the Cisco Transceiver
Modules Compatibility Information document.
The following figure shows the switch features on the power supply side of the chassis.
Grounding pad2Console port1
Fan modules (3) with slots numbered from 1 (left) to 3 (right)4Power supply modules (1 or 2) (AC
power supplies shown) with slots
numbered 1 (left) and 2 (right)
3
Cisco Nexus 9348GC-FX3 NX-OS Mode Switch Hardware Installation Guide
2
Overview
Overview