1-6
Cisco ONS 15454 DWDM Procedure Guide, R8.0
78-17704-02
Chapter 1 Install the Shelf and Common Control Cards
NTP- G1 Unpack and Inspect the Shelf Assembly
• Wire cutters
Note Ring runs are not provided by Cisco and can hinder side-by-side shelf installation where space is limited.
Tools Needed (ETSI)
To install the ONS 15454 ETSI, you need the following tools.
• #2 Phillips Dynamometric screwdriver
• Medium slot-head screwdriver
• Small slot-head screwdriver
• Video fiber connector inspection instrument
• CLETOP cleaning cassette
• Crimping tool—This tool must be large enough to accommodate the girth of the grounding lug when
you crimp the grounding cable into the lug.
• Wire stripping tool
Test Equipment (ETSI)
To install the ONS 15454 ETSI, you need the following test equipment.
• Voltmeter
• Power meter (only for use with fiber optics)
• BER tester for E1-N-14, E1-42, E3-12, DS3i-N-12, STM1E-12, and FMEC cards
NTP-G1 Unpack and Inspect the Shelf Assembly
Step 1 Complete the “DLP-G1 Unpack and Verify the Shelf Assembly” task on page 1-7.
Step 2 Complete the “DLP-G2 Inspect the Shelf Assembly” task on page 1-7.
Step 3 Continue with the “NTP-G1 Unpack and Inspect the Shelf Assembly” procedure on page 1-6.
Stop. You have completed this procedure.
Purpose This procedure explains how to unpack the ONS 15454 shelf assemblies
and verify their contents.
Tools/Equipment Pinned hex (Allen) key for front door
Prerequisite Procedures None
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
