1-65
Cisco ONS 15454 DWDM Procedure Guide, R8.0
78-17704-02
Chapter 1 Install the Shelf and Common Control Cards
NTP- G13 Install the Rear Cover (ANSI Only)
Step 2 Move the cover to the right side towards the right pin of the hinge.
Step 3 Pull the right side of the hinge-locking spring (Figure 1-29). Push the cover onto the right pin until the
spring snaps into place.
Figure 1-29 ONS 15454 ETSI FMEC Cover
Step 4
Attach the ground wire to the shelf.
Step 5 Attach the washer and nut.
Step 6 Attach the cover to the shelf using the screws on the top of the cover.
Step 7 Continue with the “NTP-G14 Install DWDM Equipment” procedure on page 1-67.
Stop. You have completed this procedure.
NTP-G13 Install the Rear Cover (ANSI Only)
71087
F
A
N
F
A
IL
C
R
IT
M
A
J
M
IN
Pin hinge
FMEC cover
Hinge-locking
spring
Purpose The following procedure explains how to install the rear cover on an
ONS 15454 ANSI shelf.
Tools/Equipment #2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Prerequisite Procedures NTP-G5 Remove the Backplane Covers (ANSI Only), page 1-28
Required/As Needed Required
To Next Page
Loading...
