Cisco ONS 15454 ETSI - Install the Y-Cable Protection Modules in the Y-Cable Module Tray

1-74
Cisco ONS 15454 DWDM Procedure Guide, R8.0
78-17704-02
Chapter 1 Install the Shelf and Common Control Cards
NTP- G377 Install the Y-Cable Protection Modules in the Y-Cable Module Tray
Step 1 According to the Cisco MetroPlanner Internal Connections Report, determine the Y-cable modules that
you want to install in the FlexLayer shelf.
Step 2 Insert the appropriate Y-cable module into the FlexLayer shelf assembly. Use a Phillips Dynamometric
screwdriver to install the two accompanying screws.
Step 3 Repeat Steps 1 and 2 as necessary for each Y-cable module you want to install. The FlexLayer shelf can
hold up to four Y-cable modules, and the Y-cable tray can hold up to eight Y-cable modules.
Step 4 Return to your originating procedure (NTP).
DLP-G377 Install the Y-Cable Protection Modules in the Y-Cable Module Tray
Step 1 According to the Cisco MetroPlanner Internal Connections Report, determine which slots you will use
to install the Y-cable modules.
Step 2 Open the drawer of the tray by pushing inward on the latches located at the left and right front of the tray.
Step 3 In the tray, pull up the latches on either side of the module frame and slide the frame upward until it is
fully extended.
Step 4 Line up the first Y-cable module that you want to install with the desired slot, pull the latch at the bottom
of the Y-cable module to enable the Y-cable module to slide onto the guides, and slide the module down
until it is fully installed in the slot. Figure 1-33 shows the Y-cable module that can be installed in the
Y-cable module tray.
Onsite/Remote Onsite
Security Level None
Purpose This task installs the Y-cable protection modules in the Y-cable module
tray. The Y-cable module tray can hold up to eight Y-cable modules.
Tools/Equipment #2 Phillips Dynamometric screwdriver
Y-cable modules: Multi-Mode Y-Cable Protection Module(s)
(15454-YCM-MM-LC) or Single-Mode Y-Cable Protection Module(s)
(15454-YCM-SM-LC), as appropriate
Cisco MetroPlanner Internal Connections Report
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None