16
Installing Collection Manager Software
Use the install-cm.sh script to install the Collection Manager server.
install-cm.sh Options
The usage message for the install-cm.sh script is:
Usage: install-cm.sh [-h] (-d CMDIR | -o)
Options: -d CMDIR select directory for ~scmscm
(must not exist and must be on 8 GB free partition)
-o upgrade the existing installation
while preserving the current configuration
(can't be used with -d)
-h print this help and exit
The description of the options is as follows:
-d CMDIR
Used to designate the directory of the newly created
scmscm user's home. Should be the name of a
non-existing directory, whose parent resides on a
partition where at least 8 GB is free.
As an alternate to this option, you can specify -o :
-o
Use this option when you wish to upgrade the existing
installation while preserving the current configuration.
(can't be used with -d)
For information about the actions performed by the install-cm.sh script, see the Cisco Service Control Management Suite
Collection Manager User Guide.
Install the Collection Manager server by performing the following procedure:
Step 1 Change directory to install-scripts under the distribution kit root.
Step 2 Run the install-cm.sh script:
# install-cm.sh -d <CM home dir>
After running the script, a user-driven configuration manager presents the user with options for the basic configuration
of the Collection Manager.
Step 3 Choose whether to enable the verbose mode. If enabled, verbose mode displays a detailed installation log on the
console. The default value is no.
Do you want to enable verbose mode (for detailed installation) (yes/no)[no]:
Step 4 You can choose to set up the Collection Manager database at the time of installation or configure it at a later time.
Would you like to configure the database?(yes/no) [yes]:
To Next Page
Loading...
Need help?
General
