Cisco SCE 8000 - Initial Cisco SCA BB Configuration; How to Use the Usage Analysis Wizard to Define the Default Site

32
• RDR formatter destination—The Cisco SCE platform generates RDRs and sends them to the specified destinations (external
collection systems) via the RDR formatter. You can configure up to eight RDR formatter destinations. Specify the IP address
and port number for each destination.
Table 8 lists the commands both for displaying the currently configured values and for configuring these parameters. It also lists
the command mode for each configuration command. All the show commands are executed in the user EXEC command mode.
Initial Cisco SCA BB Configuration
Initial SCA BB configuration includes two main aspects:
• Defining your site—Defining all your Cisco Service Control components. Use the Usage Analysis wizard to define your site.
• Defining a basic service configuration.
Usage Analysis Wizard
Use this wizard to perform these tasks:
• Create the site.
• Create a service configuration called Usage Analysis with the following characteristics:
– The mode is set to Report Only.
– The maximum Transaction RDR rate is set as the default value (250) divided by the number of Cisco SCE devices.
How to Use the Usage Analysis Wizard to Define the Default Site
The Usage Analysis wizard allows you to create a simple model of devices and connect to them.
Note If they do not exist, the devices defined in the wizard are added to the default site in the Site Manager tree.
Table 8 Initial Setup Configuration
Parameter show Command Configuration Command
Configuration Command
Mode
Management IP address
and subnet mask
show interface GigabitEthernet
1/1 ip address
ip address x.x.x.x subnet-mask GigabitEthernet
interface configuration
Default gateway show ip default-gateway ip default-gateway x.x.x.x Global configuration
Hostname show hostname hostname host-name Global configuration
Authorization-level
passwords
— enable password level level
[encryption-type] password
Global configuration
Clock show clock
show calendar
calendar set hh:mm:ss day month
year
clock read-calendar
or
clock set hh:mm:ss day month year
clock update-calendar
Privileged EXEC
Time zone show timezone clock timezone zone-name
offset-hours
Global configuration
Domain name server show hosts ip domain-lookup
ip domain-name domain-name
ip name-server server-address1
[server-address2] [server-address3]
Global configuration
RDR formatter
destination
show rdr-formatter destination rdr-formatter destination ip-address
port port-number
Global configuration