Cisco SD208T-NA User Manual

Smartports
Configuring Smartport Using The Web-based Interface
Cisco Small Business 200 Series Smart Switch Administration Guide 134
10
Smartport Type Settings
Use the Smartport Type Settings page to edit the Smartport Type settings and
view the Macro Source.
By default, each Smartport type is associated with a pair of built-in Smartport
macros. See Smartport Types for further information on macro versus anti-macro.
Built-in or user-defined macros can have parameters. The built-in macros have up
to three parameters.
Editing these parameters for the Smartport types applied by Auto Smartport from
the
Smartport Type Settings page configures the default values for these
parameters. These defaults are used by Auto Smartport.
NOTE Changes to Auto Smartport types cause the new settings to be applied to
interfaces which have already been assigned that type by Auto Smartport. In this
case, binding an invalid macro or setting an invalid default parameter value causes
all ports of this Smartport type to become unknown.
STEP 1 Click Smartport > Smartport Type Settings. The Smartport Type Settings page
opens.
STEP 2 To view the Smartport macro associated with a Smartport type, select a
Smartport type and click View Macro Source.
STEP 3 To modify the parameters of a macro, select a Smartport type and click Edit. The
Edit Smartport Type Settings page opens.
STEP 4 Enter the fields.
• Port Type—Select a Smartport type.
• Macro Name—Displays the name of the Smartport macro currently
associated with the Smartport type.
• Macro Parameters—Displays the following fields for three parameters in the
macro:
- Parameter Name—Name of parameter in macro.
- Parameter Value—Current value of parameter in macro. This can be
changed here.
- Parameter Description—Description of parameter.
You can restore the default parameter values by clicking Restore Defaults.

Cisco SD208T-NA Specifications

General

Brand	Cisco
Model	SD208T-NA
Category	Switch
Language	English