Cisco SE-CL-L3 - Page 5

Enabling or Disabling the Internal USB Port 57
Replacing the RTC Battery 58
Replacing Power Supplies 59
Replacing AC Power Supplies 59
Replacing a PCIe Card 60
PCIe Slot Specifications 60
Replacing a PCIe Card 61
Cisco Virtual Interface Card (VIC) Considerations 64
Replacing an mLOM Card 65
Replacing an mRAID Riser (Riser 3) 66
Replacing a SAS Storage Controller Card (RAID or HBA) in Riser 3 68
Storage Controller Card Firmware Compatibility 68
Replacing a SAS Storage Controller Card (RAID or HBA) 69
Replacing a Boot-Optimized M.2 RAID Controller Module 70
Cisco Boot-Optimized M.2 RAID Controller Considerations 70
Replacing a Cisco Boot-Optimized M.2 RAID Controller 71
Replacing the Supercap (RAID Backup) 73
Replacing a SATA Interposer Card 75
Replacing a Chassis Intrusion Switch 76
Installing a Trusted Platform Module (TPM) 77
TPM Considerations 77
Service Headers and Jumpers 78
Using the Clear CMOS Header (J38, Pins 9 - 10) 79
Using the BIOS Recovery Header (J38, Pins 11 - 12) 80
Procedure 1: Reboot With recovery.cap File 80
Procedure 2: Use BIOS Recovery Header and bios.cap Recovery File 81
Using the Clear Password Header (J38, Pins 13 - 14) 81
Using the Boot Alternate Cisco IMC Image Header (J39, Pins 1 - 2) 82
Using the Reset Cisco IMC Password to Default Header (J39, Pins 3 - 4) 83
Using the Reset Cisco IMC to Defaults Header (J39, Pins 5 - 6) 84
Server Specifications 85
APPENDIX A
Server Specifications 85
Physical Specifications 85
Cisco Application Services Engine Hardware Installation Guide
v
Contents